Product Guide

How to Identify Compressor Parts

The information that gets you the right part the first time.

1. Start with the nameplate

Every compressor has a nameplate or data label. Photograph it clearly, straight on, in good light. The most important fields are:

  • Model / type designation — the full code, including suffixes.
  • Serial number — helps identify production variants.
  • Electrical data — voltage, phase, frequency and current.
  • Refrigerant and oil — where shown.

2. Find the part number

Original parts often carry a part number stamped or printed on them. Manufacturer spare-parts lists for the compressor series also show part numbers against exploded diagrams. If you have the old part, photograph any markings on it.

3. Measure if needed

For parts such as piston rings, gaskets and seals, dimensions help confirm a match: bore diameter, ring width, shaft diameter or gasket pattern.

4. Describe the job

Tell us whether it’s a single part replacement or a full overhaul. A valve plate replacement, for example, also needs the matching gaskets.

Common compressor parts

PartTypical symptom when worn or failed
Valve plate / reedsLow capacity, high discharge temperature, poor pump-down
Piston ringsLow capacity, high oil carry-over
BearingsNoise, low oil pressure, high current
Oil pumpOil pressure failure trips
Shaft sealOil or refrigerant leak at the shaft (open-drive)
GasketsLeaks at joints after opening
Terminal plateLeaks or electrical faults at the terminals

Send it to us

Brand, model, part number and photos — that’s all we need. See compressor parts.